Mount Bracket for dinghy motor

[Hensch42]

I have looked almost everywhere as to where to purchase the mount …. Any suggestions?

 

[bob daily]

Outboard rail motor mount at Amazon, numerous ones available at around $40

 

[JMarshallR25]

Outboard rail motor mount at Amazon, numerous ones available at around $40

I assume he’s referencing the entire unit including the stainless tubing, not merely the plastic square.

 

[Hensch42]

Thx for the comeback…. Yes, my interest is in locating the tubing.. really the whole thing if so available.. it’s a three legged tubing, which I believe it will not cover up the lettering.. I’ve looked @ Amazon & couldn’t locate one.

 

[Eagle 2]

Any good local stainless welder in your market could make this for you based on your measurements. Probably a bit more $$$ but it would be custom fit for your boat specifically.

 

[Red Raven]

I believe Bolton Stainless in BC makes nearly all the stainless railings for Fluid Motion. They are Wholesale only but perhaps a call to Fluid Motion would help in case they had some of these made for them?

 

[cliffm]

I'd contact Fluid motion for the appropriate option for your boat model

 

[Hensch42]

Yeah, I did. Then had a response from Fluid Motion Parts, & they are to research, since many parts are sourced by various manufacturers. No update as yet.

 

[Hensch42]

Very interesting approach.. certainly a reasonable priced project.. thx

 

[Mike and Sarah]

Friend with a 2021 r27 says his boat had it the mount like the one in the picture installed when he got the boat. It was around $450 at that time.
I’m guessing the design is the same on new boats too.

 

[Hensch42]

I would not doubt it’s more that now.. everything from them is way up there, like 500% upcharge. the approach of getting the ttube holder from Amazon, as suggested earlier look like a way to go.. all I need now is to find someone that could bend to shape the 1” tube, or get a tube bender. I’ll keep on trying - have to find somehow how to carry a small outboard.