At the helm...the wire runs down through a small rigging hole on the starboard side. At the transducer (located under the step down to the v-berth)...the wire runs to port, so it must crossover somewhere, right? If anyone has some ideas for me, I'd sure love to hear them! I don't think I can...
Hi, Were wondering where the In-line strainer for the SeaEra toilet is located on our 2023 R25 ?
We are not getting water flow into the toilet, the seacock is open and the Aqua Jet Wash Down System is operating normally.
We are trying to determine what the problem is as the toilet was operating...
First question is this normal, if it isn't how can I tighten it back up?
I'm assuming I can pop off the logo cap on the front of the wheel and tighten down a lock nut... am I on the right track? How do I get the cap off is it press fit or threaded or...?
Is Ranger Tugs researching the auto leveling trim tabs for the R25 like was done on the Solara S25 Coupe? If so, what solution does it look like might make it to the R25?
Hi there, is it possible to purchase a replacement black seat clip for my helm seat in my 2024 R-25 outboard? Mine had some give in it between the plastic clip and the metal latch so it had a tiny bit of give, and going through some chop with more of my weight shifting to the front of my seat...
Sorry to bother you guys with this but I could not seem to find an exact match for this in the general discussion search. Going through my R25 books this weekend I could not find the book on my Thruster. Since I dont know the make and model I cant order the shear pin. My Hull # FMLT2506G425...
I am in the market for a used Ranger R-23 or R-25 in good condition with trailer. It will be run on Cape Cod and I am willing to travel. Thank you for your help!
We just hauled out our R25 for the season and notices barnacles in the bow thruster port and on the thruster blades too. What is the best way to eliminate these barnacles? Is a disassembly required and if so are there detailed instructions on how to do this without creating a bigger problem...
I have a 2021 RT25LE. My thruster battery has one ground cable that I believe to be going to the thruster motor. The wiring schematic diagram shows the thruster battery to be grounded to the engine battery. Is this correct? I hesitate to add the ground cable without advice. What has/had me...
My R25 is 2 years old and I need to replace the SD card in the 1243xsv chart plotter. The plotter is built in. How do I remove it to access the panel to insert the card. is there another way that I am missing? Please advise,
Hi Team,
New 2024 Ranger Tug R-25 with what I believe is excessive Webasto condensate building up. So much so that it is sloshing out underway and leaking into cave. See photos below and video here...
https://drive.google.com/file/d/1mO2-tOLCVK8Jamubp7_A3VAln2l4Cq6B/view?usp=drivesdk
Have a Ranger R25 2023, at about 18 months the six pieces of SeaDek on the swim step all starting coming up on edges. Had the boat on the hard to have the bottom repainted at 24 months and had the company reglue edges with 3M 77 some areas coming up 6inches into each piece. About six months ago...
Hi fellas,
Does anyone have a copy of the F250 fuel consumption chart as tested by the factory folks on an R25 outboard? I believe it used to be posted on the Ranger tugs website, but I haven’t seen it lately. It showed engine rpm, boat speed, fuel flow at various rpm settings with...
I just received my Ranger Tug R25 about three weeks ago. I have what I hope is a simple question. Please review the attached screen shot of my Victron Smart BMV. At the bottom of the screen it says under Input- Starter Battery- 0.03V. Is that normal? I know the battery is fine because it starts...
Hello,
Couldn't find anything in the search about suggestions for places to mount the placard. The one I purchased is made from starboard and I'm told there is no type of epoxy that will hold by itself so I will also need to drill and run screws into the mounting location. This looks like a...
What settings does the factory recommend for the Victron BMV-712 on an R25 with 600 AH of Dakota lithium batteries in order to obtain accurate readings of time remaining, percent consumed, etc.? Currently, the monitor is providing inaccurate readings and generally showing 100% charge at all...
Fellow Tugnuts,
I’m taking delivery of a new 2025 R-27 in a little over a month. What are some things that I need to be gathering/purchasing for that first day trip or overnight?
Also, is the boat missing anything that I need when I take it from Des Moines to Foss Harbor Marina? Don’t want to...